![]() The following phone baseband subcommands will return the corresponding results in your logcat: Subcommand See table below for available subcommands. Simulates an incoming text message from a given phone number. ![]() Simulates an incoming phone call from a given phone number. The phone command interact with the Phone widget. Genymotion Shell > network setprofile wifi The value must range from -10000m to 10000m. disabled: the GPS signal reception is disabled.enabled: the GPS signal reception is enabled.Sets the activation status of the GPS signal reception: Returns the activation status of the GPS signal reception. The gps command interacts with the GPS widget. full: simulates that the battery is fully charged.notcharging : simulates that the power supply has just been unplugged and the battery is not discharging yet.charging : simulates that the power supply is plugged in and the battery is charging.discharging : simulates that the power supply is unplugged and the battery is discharging.Sets the battery state of charge of the selected virtual device: Returns the current battery state of charge of the selected virtual device. This command forces the activation of the manual mode. Sets the battery charge level of the selected virtual device. If the battery mode is host, the returned value is the host value. Returns the current battery charge level of the selected virtual device. manual: the virtual battery charge level and state of charge can be manually set. ![]() host: the virtual battery values reflect the host battery values (if any).Sets the battery mode of the selected virtual device: Returns the current battery mode of the selected virtual device. The battery commands interact with the Battery widget. Id | Select | Status | Type | IP Address | Name |- | | No Genymotion virtual device running found | | Please, run at least one Genymotion virtual device to use this shell | |- | Adding the option force at the end skips the warning message about data loss. Add the ID of the device you wish to reset (as displayed in the device list). Resets the virtual device to factory state. Sends a ping message to check that the virtual device is responding. Add the ID of the virtual device you wish to select (as displayed in the device list). Lists available virtual devices and provides details such as current status, IP address and name. The devices command interacts or returns results about virtual devices themselves. This section lists available commands of each category. To modify sensor statuses and values of a virtual device, Genymotion Shell provides commands grouped by category corresponding to the component of the virtual device they interact with. Pauses the execution of Genymotion Shell. With the commands below, you can perform various basic actions related
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |